Which dynamic routing protocol was developed to interconnect different Internet service providers?

Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks?

What two tasks do dynamic routing protocols perform? (Choose two.)

When would it be more beneficial to use a dynamic routing protocol instead of static routing?

When would it be more beneficial to use static routing instead of dynamic routing protocols?

What is a purpose of the network command when configuring RIPv2 as the routing protocol?

A network administrator configures a static route on the edge router of a network to assign a gateway of last resort. How would a network administrator configure the edge router to automatically share this route within RIP?

What is the purpose of the passive-interface command?

Which route would be automatically created when a router interface is activated and configured with an IP address?

Refer to the exhibit. Which two types of routes could be used to describe the 192.168.200.0/30 route? (Choose two.)

What occurs next in the router lookup process after a router identifies a destination IP address and locates a matching level 1 parent route?

Which route would be used to forward a packet with a source IP address of 192.168.10.1 and a destination IP address of 10.1.1.1?

Which two requirements are used to determine if a route can be considered as an ultimate route in a router’s routing table? (Choose two.)

What is a disadvantage of using dynamic routing protocols?

Which two statements are true regarding classless routing protocols? (Choose two.)

Refer to the exhibit. Based on the partial output from the show ip route command, what two facts can be determined about the RIP routing protocol? (Choose two.)

While configuring RIPv2 on an enterprise network, an engineer enters the command network 192.168.10.0 into router configuration mode.

What is the result of entering this command?

A destination route in the routing table is indicated with a code D. Which kind of route entry is this?

Refer to the exhibit. Which interface will be the exit interface to forward a data packet with the destination IP address 172.16.0.66?

Which type of route will require a router to perform a recursive lookup?

Which route is the best match for a packet entering a router with a destination address of 10.16.0.2?

A router is configured to participate in multiple routing protocol: RIP, EIGRP, and OSPF. The router must send a packet to network 192.168.14.0. Which route will be used to forward the traffic?

What is different between IPv6 routing table entries compared to IPv4 routing table entries?

Match the dynamic routing protocol component to the characteristic. (Not all options are used.)

Match the characteristic to the corresponding type of routing. (Not all options are used.)