CCNA 2 Chapter 7 v5 Exam Answers 2016

1
What is the purpose of the passive-interface command?

2
What two tasks do dynamic routing protocols perform? (Choose two.)

3
Fill in the blank. Do not abbreviate the answer.

4

Refer to the exhibit. OSPF is used in the network. Which path will be chosen by OSPF to send data packets from Net A to Net B?

5
Which two statements are true regarding classless routing protocols? (Choose two.)

6
What two actions result from entering the network 192.168.1.0 command in RIP configuration mode on a router? (Choose two.)

7

Refer to the exhibit. Based on the partial output from the show ip route command, what two facts can be determined about the RIP routing protocol? (Choose two.)

8. Match the router protocol to the corresponding category. (Not all options are used.)

9
In the context of routing protocols, what is a definition for time to convergence?

10
Fill in the blank. Do not abbreviate.

11
A destination route in the routing table is indicated with a code D. Which kind of route entry is this?

12

Refer to the exhibit. Which interface will be the exit interface to forward a data packet with the destination IP address 172.16.0.66?

13
Which route is the best match for a packet entering a router with a destination address of 10.16.0.2?

14
Which two requirements are necessary before a router configured with a link-state routing protocol can build and send its link-state packets? (Choose two.)

15
Which two requirements are used to determine if a route can be considered as an ultimate route in a router’s routing table? (Choose two.)

16
What is different between IPv6 routing table entries compared to IPv4 routing table entries?

17
Which dynamic routing protocol was developed as an exterior gateway protocol to interconnect different Internet providers?

18
Which route will a router use to forward an IPv4 packet after examining its routing table for the best match with the destination address?

19
Which two statements describe the OSPF routing protocol? (Choose two.)

20
Which two events will trigger the sending of a link-state packet by a link-state routing protocol? (Choose two.)

21

Place the options in the following order:

22

23.

Refer to the exhibit. A network administrator has issued the exhibited commands in an attempt to activate RIPng on interface gig0/0. What is causing the console message that is shown after RIP is enabled?

24. Which type of route will require a router to perform a recursive lookup?

25. After a network topology change occurs, which distance vector routing protocol can send an update message directly to a single neighboring router without unnecessarily notifying other routers?

26. An OSPF enabled router is processing learned routes to select best paths to reach a destination network. What is the OSPF algorithm evaluating as the metric?

27. What is a disadvantage of using dynamic routing protocols?

28. While configuring RIPv2 on an enterprise network, an engineer enters the command network 192.168.10.0 into router configuration mode. What is the result of entering this command?

29. Which routing protocol uses link-state information to build a map of the topology for computing the best path to each destination network?

30. A router is configured to participate in multiple routing protocol: RIP, EIGRP, and OSPF. The router must send a packet to network 192.168.14.0. Which route will be used to forward the traffic?

31. When does a link-state router send LSPs to its neighbors?